NEC Express5800/120Rd-2 Service Manual page 74

2-10 Setting Up Your Server
Installing the Rail Assemblies
Align the left slide rail assembly behind the mounting holes in the vertical-mounting rail
1.
located on the left side of the rack cabinet. The catch tabs on the front and rear of the
slide rail assembly help to align it with the holes in the vertical-mounting rail.
2. Install two screws that secure the front of the slide rail assembly to the front vertical-
mounting rail and loosely tighten them.
3. Carefully align the rear holes of the slide rail assembly with the holes in the rear vertical-
mounting rail.
Install two screws that secure the rear of the slide rail assembly to the vertical-mounting
4.
rail.
5. Tighten all four screws holding the slide rail assembly to the vertical mounting rails.
Repeat steps 1 through 5 for the mounting the right slide rail assembly on the right side
6.
of the rack cabinet.
Note: The screws in the oblong slots of the outer slide rail may need
to be readjusted and tightened.
Catch
Screw hole for securing the
server to the rack
Three screw slots should be
visible in the range of "1U."