NEC Express5800/120Rd-2 Service Manual page 98

3-8 Configuring Your System
Select [Advanced] - [PCI Configuration] and set up each device.
To install the disk array controller
Select [Advanced] - [PCI Configuration] - [PCI Slot nx ROM] - [Enabled].
nx= Riser card number (n: 1 to 3) and type (x: C is low-profile type and B is full-
length/full-height type)
To clear the hardware configuration data (after installing/removing internal devices)
Select [Advanced] - [Reset Configuration Data] - [Yes].
Saving the Configuration Data
To save the BIOS configuration data
Select [Exit] - [Exit Saving Changes].
To discard changes to the BIOS configuration data
Select [Exit] - [Exit Discarding Changes] or [Discard Changes].
To resume the factory-set BIOS configuration data
Select [Exit] - [Load Setup Defaults].
To save the current settings as user-defined configuration
Select [Exit] - [Save Custom Defaults].
To load the user-defined configuration data
Select [Exit] - [Load Custom Defaults].