NEC Express5800/120Rd-2 Service Manual page 62

1-44 System Overview
After removing the CD, close the tray.
To remove a CD from the CD-ROM drive when the power is off, follow the procedure below.
1. Press the POWER switch to power off the server. The POWER lamp goes off.
2. Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length (a
straightened large paper clip) into the emergency hole on the right front of the CD-ROM
drive and gently push it in until the tray opens.
IMPORTANT:
Do not use a toothpick or plastic stick that is easy to break.
!
If the above procedure does not open CD-ROM drive, contact your
!
service representative.
Hold the tray and pull it out.
3.
Remove the CD.
4.
Close the CD tray.
5.
Emergency hole