NEC Express5800/120Rd-2 Service Manual page 96

3-6 Configuring Your System
Memory
To enable the memory degradation feature
Select [Advanced] - [Memory Configuration] - [Extended Memory Test] - [Every-
Location].
To check the installed memory (DIMM) status
Select [Advanced] - [Memory Reconfiguration] - [Bank #n] and check the status
indications. (n: 1 - 3)
The on-screen DIMM numbers and socket locations on the system board are shown in
the figure below.
Bank #3 (DIMM 3B)
Bank #2 (DIMM 2B)
Bank #1 (DIMM 1B)
Bank #3 (DIMM 3A)
Bank #2 (DIMM 2A)
Bank #1 (DIMM 1A)
REAR
To clear the memory (DIMM) error information
Select [Advanced] - [Memory Configuration] - [Memory Retest] - [Enabled] and reboot
the server.
Mother board
Processor 2
Processor 1
FRONT