D-Link UWS User Manual
Outbound Telnet Client Configuration
The outbound telnet feature is not available on all platforms.
Use the outbound telnet client settings to control the telnet sessions that originate from the switch and
connect to a remote system.
To access the Outbound Telnet Client Configuration page, click LAN > Administration > Outbound Telnet
Client Configuration in the navigation menu.
Field
Admin Mode
Maximum Sessions
Session Timeout
• If you change any data, click Submit to apply the changes to the system. If you want the switch to retain
the new values across a power cycle, you must perform a save.
D-Link
Oct. 2015
Figure 27: Outbound Telnet
Table 22: Outbound Telnet Fields
Description
Specifies whether the Outbound Telnet service is Enabled or Disabled. The
default value is Enabled.
• Enable: Users can initiate outbound telnet sessions from the switch CLI.
• Disable: No outbound telnet sessions can originate from the switch.
Specifies the maximum number of Outbound Telnet Sessions allowed. The
default value is 5. The valid range is 0 to 5 sessions.
Specifies the Outbound Telnet login inactivity timeout. The default value is 5.
The valid range is 1 to 160 minutes.
Outbound Telnet Client Configuration
Unified Wired and Wireless Access System
Page 94