D-Link UWS User Manual
Adding a Port Mirroring Session
Note: A Port will be removed from a VLAN or LAG when it becomes a destination mirror.
1. From the LAN > Administration > Multiple Port Mirroring page, click Add Source Port to display the Add
Source Port page.
2. Configure the following fields:
Field
Session ID
Source Port(s)
Direction
3. Click Add to apply the changes to the system.
The new port mirroring session is enabled for the unit and port, and the device is updated. The source port
appears in the Source Port list on the Multiple Port Mirroring page.
D-Link
Oct. 2015
Figure 25: Multiple Port Mirroring—Add Source Ports
Table 20: Multiple Port Mirroring—Add Source Fields
Description
Specifies the monitoring session.
Select the unit and port from which traffic is mirrored. Up to eight source
ports can be mirrored to a destination port.
Select the type traffic monitored on the source port, which can be one of the
following:
• Tx: Monitors transmitted packets only.
• Rx: Monitors received packets only.
• Tx and Rx: Monitors transmitted and received packets.
Multiple Port Mirroring
Unified Wired and Wireless Access System
Page 91