D-Link UWS User Manual
Command Buttons
The page includes the following buttons:
• Submit—Update the switch with the values you enter.
WDS Link Configuration
After you create a WDS-Managed AP group, use the WDS AP Link Configuration page to configure the WDS
links between the APs that are members of the group.
Note: After you change WDS-Managed AP group settings, make sure you push the configuration to
other switches in the cluster.
The following table shows the fields available on the WDS AP Link Configuration page.
Field
WDS Group ID
Source AP MAC
Address
Source Radio
Source AP Hardware
Type
Dest AP MAC Address The MAC address of the destination AP in the group.
Destination Radio
Destination AP
Hardware Type
Link Cost
D-Link
Oct. 2015
Figure 406: WDS AP Link Configuration
Table 372: WDS AP Link Configuration
Description
Select the ID associated with the group to configure.
MAC Address of the source AP. The AP must be included in the selected WDS group.
Note: The WDS links are bidirectional. The terms Source and Destination simply
reflect the WDS link endpoints specified when the WDS link is created.
The radio number of the WDS link endpoint on the source AP.
The hardware type identifier associated with the source AP.
The radio number of the WDS link endpoint on the destination AP.
The hardware type identifier associated with the destination AP.
Spanning Tree Path cost for the WDS link. The range is 0–255.
When multiple alternate paths are defined in the WDS group, the link cost is used to
indicate which links are the primary links and which links are the secondary links. The
spanning tree selects the path with the lowest link cost.
Configuring the Wireless Distribution System
Unified Wired and Wireless Access System
Page 648