Acl Interface Configuration; Figure 250: Acl Interface Configuration; Table 216: Acl Interface Configuration Fields - D-Link DWL-8600AP User Manual

Dws-4000 series access points

Hide thumbs Also See for DWL-8600AP:

Table of Contents

D-Link UWS User Manual

ACL Interface Configuration

When an ACL is bound to an interface, all the rules that have been defined are applied to the selected

interface. Use the ACL Interface Configuration page to assign ACLs and Interfaces and prioritize the ACLs that

are bound to each interface. To display the ACL Interface Configuration page, click LAN > QoS > Access Control

Lists > Interface Configuration in the navigation menu.

If an ACL has been assigned to the interface, it displays in the table at the bottom of the page.

Sequence Number

Select the interface or LAG from the menu.

Specifies the packet filtering direction for the ACL. The system supports

Inbound filtering. inbound filtering means the system applies the ACL rules to

packets as they enter the interface.

Use the menu to select the ACL type to which incoming packets are matched.

Packets can be matched to IP- or MAC-based ACLs.

Select the ACL of the specified type to apply to the interface from the

dropdown menu.

Assigns the priority of this ACL. If more than one ACL is applied to an interface,

then the match criteria for the highest sequence ACLs are checked first. A

lower number indicates higher priority. If a sequence number is already in use

for this interface and direction, the specified access list replaces the currently

attached access list using that sequence number. If you do not specify a

sequence number, a sequence number that is one greater than the highest

sequence number currently in use for this interface and direction is used. The

valid range is 1-4294967295.

ACL Interface Configuration

Unified Wired and Wireless Access System

Show Quick Links

Table of Contents