Sntp Server Configuration; Figure 31: Sntp Server Configuration; Table 26: Sntp Server Configuration Fields - D-Link DWL-8600AP User Manual

Dws-4000 series access points

Hide thumbs Also See for DWL-8600AP:

Table of Contents

D-Link UWS User Manual

Unicast Poll Timeout

Unicast Poll Retry

• If you change any of the settings on the page, click Submit to apply the changes to system.

SNTP Server Configuration

Use the SNTP Server Configuration page to view and modify information for adding and modifying Simple

Network Time Protocol SNTP servers.

To display the SNTP Server Configuration page, click LAN > Administration > SNTP > SNTP Server

Configuration in the navigation tree.

Address / Hostname

Address Type

Table 25: SNTP Global Configuration Fields (Cont.)

Specifies the number of seconds to wait for an SNTP response when

configured in unicast mode. Allowed range is (1 to 30). Default value is 5.

Specifies the number of times to retry a request to an SNTP server after the

first time-out before attempting to use the next configured server when

configured in unicast mode. Allowed range is (0 to 10). Default value is 1.

Select the IP address of a user-defined SNTP server to view or modify

information about an SNTP server, or select Create to configure a new SNTP

server. You can define up to three SNTP servers.

Enter the IP address or the hostname of the SNTP server.

Select IPv4 if you entered an IPv4 address or DNS if you entered a hostname.

Enter a port number from 1 to 65535. The default is 123.

Specifies the priority of this server entry in determining the sequence of

servers to which SNTP requests are sent. Values are 1 to 3, and the default is

1. Servers with lowest numbers have priority

Enter the protocol version number. Values are 1 to 4, and the default is 4.

Configuring SNTP Settings

Unified Wired and Wireless Access System

Show Quick Links

Table of Contents