D-Link DWL-8600AP User Manual page 721

D-Link UWS User Manual
A message appears and indicates that the AP radios will be reset, which will disassociate any associated
wireless clients. Click OK to continue.
5. View the transmit power for the associated APs by clicking WLAN > Monitoring > Access Points > Managed
AP Status > Radio Summary.
6. Go to the WLAN > Administration > AP Management > RF Management page and note the Power
Adjustment Mode setting.
The default mode is Manual. If the mode is Interval, you cannot run the APA algorithm manually.
7. Click the Manual Power Adjustment tab.
8. Click Start to allow the algorithm to run and determine whether any power adjustments are appropriate.
9. To view the adjustments that the APA algorithm recommends, click Refresh.
Note: The APA recommends power adjustments based on the presence or absence of packet
transmission errors. A high number of packet transmission errors indicates that the signal strength
might be too low and that wireless clients are unable to successfully transmit traffic. If no wireless
clients are connected to the AP, no power adjustments will be recommended.
D-Link
July 2012
Optimizing WLAN Traffic
Unified Wired and Wireless Access System
Page 721