Rip Interface Summary; Figure 197: Rip Interface Summary; Table 179: Rip Interface Summary Fields - D-Link DWL-8600AP User Manual

D-Link UWS User Manual

RIP Interface Summary

Use the RIP Interface Summary page to display RIP configuration status on an interface.
To display the page, click LAN > Monitoring > L3 Status > RIP > Interface Summary in the navigation tree.
Field
Interface
IP Address
Send Version
Receive Version
RIP Admin Mode
Link State
• Click Refresh to update the information on the screen.
D-Link
Oct. 2015

Figure 197: RIP Interface Summary

Table 179: RIP Interface Summary Fields

Description
The interface, such as the routing-enabled VLAN on which RIP is enabled.
The IP Address of the router interface.
Specifies the RIP version to which RIP control packets sent from the interface
conform. The default is RIP-2. Possible values are:
• RIP-1: RIP version 1 packets are sent using broadcast.
• RIP-1c: RIP version 1 compatibility mode. RIP version 2 formatted packets
are transmitted using broadcast.
• RIP-2: RIP version 2 packets are sent using multicast.
• None: RIP control packets are not transmitted.
Specifies which RIP version control packets are accepted by the interface. The
default is Both. Possible values are:
• RIP-1: only RIP version 1 formatted packets are received.
• RIP-2: only RIP version 2 formatted packets are received.
• Both: packets are received in either format.
• None: no RIP control packets are received.
Specifies whether RIP is Enabled or Disabled on the interface.
Specifies whether the RIP interface is up or down.
Unified Wired and Wireless Access System
Configuring RIP
Page 308