Appendix A: Configuration Examples; Configuring Vlans - D-Link DWL-8600AP User Manual

Dws-4000 series access points

Hide thumbs Also See for DWL-8600AP:

Table of Contents

D-Link UWS User Manual

Appendix A: Configuration Examples

This appendix contains examples of how to configure selected features available in the Unified Wired and

Wireless Access System software. Each example contains procedures on how to configure the feature by using

the Web interface, CLI, and SNMP.

This appendix describes how to perform the following procedures:

Configuring VLAN Routing

Configuring Multiple Spanning Tree Protocol

Configuring a Virtual Access Point

Configuring Differentiated Services for VoIP

Configuring a Network with WDS-Managed APs

Configuring a Network to Use WPA2-Enterprise and Dynamic VLANs

Optimizing WLAN Traffic

Detecting and Preventing Wireless Intrusion

Note: Each configuration example starts from a factory-default configuration unless otherwise noted.

Configuring VLANs

The diagram in this section shows a switch with four ports configured to handle the traffic for two VLANs. Port

0/2 handles traffic for both VLANs, while port 0/1 is a member of VLAN 2 only, and ports 0/3 and 0/4 are

members of VLAN 3 only.

The following examples show how to create VLANs, assign ports to the VLANs, and assign a VLAN as the default

VLAN to a port.

Configuration Examples

Unified Wired and Wireless Access System

Show Quick Links

Table of Contents