Access Point Profile Radio Configuration - D-Link DWL-8600AP User Manual

D-Link UWS User Manual
Field Description
DDP Support
DDP (D-Link Discover Protocol) supports basic command (IP, factory reset, F/W upgrade,
etc.) to setting UAP, and user can use DNA (D-Link Network Assistance) to control UAP.
factory default is disabled
• Enable: Enables the DDP support
• Disable: Disables the DDP support
AeroScout™ AeroScout Engine support provides location-based services for wireless networks. Specify
Engine Support whether to enable support for the AeroScout protocol.
For more information about the AeroScout protocol, see
Support" on page
Wired Network Enter the VLAN ID that the switch uses to send tracer packets in order to detect APs
Discovery VLAN connected to the wired network.
ID
The tracer packets help the switch identify unauthorized APs that do not belong to the
Unified Wired and Wireless Access System but are connected to the wired network.
Command Buttons
The page includes the following buttons:
• Clear—Resets the profile configuration settings to the default values. The Profile Name is not cleared.
• Delete—Deletes the profile. This button is not available on the configuration page for the Default profile.
You can rename the Default profile, but you cannot delete it.
• Refresh—Updates the page with the latest information.
• Submit—Updates the switch with the values you enter. To retain the new values across a power cycle,
you must perform a save (Tool > Save Changes).

Access Point Profile Radio Configuration

To accommodate a broad range of wireless clients and wireless network requirements, the AP can support up
to two radios. By default, Radio 1 operates in the IEEE 802.11b/g/n mode, and Radio 2 operates in the IEEE
802.11a/n mode. The difference between these modes is the frequency in which they operate. IEEE 802.11b/
g/n operates in the 2.4 GHz frequency, and IEEE 802.11a/n operates in the 5 GHz frequency of the radio
spectrum.
Note: The DWL-3600AP is a single-radio AP. Only the settings you configure for Radio 2 (802.11b/g/n)
are applied to the DWL-3600AP.
The Access Point Profile Radio Configuration page contains several fields that are not available on the Basic
Setup > Radio page for the default AP Profile.
D-Link
Oct. 2015
Table 354: Access Point Profile Global Configuration
641.
Configuring Advanced Settings
"Enabling AeroScout™ Engine
Unified Wired and Wireless Access System
The
Page 609