Configuring A Virtual Access Point; Table 387: Vap Configuration Example Settings - D-Link DWL-8600AP User Manual

D-Link UWS User Manual
12. To enable IEEE 802.1X authentication on the switch, go to the LAN > Security > Port Access Control >
Configuration page, select Enable from the Administrative Mode menu, and then click Submit.
13. To set the 802.1X mode for port 0/1, go to the LAN > Security > Port Access Control > Port Configuration
page, select Force Authorized from the Control Mode field, and then click Submit.

Configuring a Virtual Access Point

The following example shows how to configure the default virtual access point (VAP) profile on the switch.
After the switch authenticates an AP it discovers on the network, it assigns the default profile to the AP. In
order for the switch and AP to discover each other, the WLAN Switch feature must be enabled on the UWS,
and the Managed Mode must be enabled on the AP.
The default profile in this example has three enabled VAPs with the following settings:
Network (SSID) VLAN
Visitor 10
Corporate 20
Voice 30
The Voice network uses the default RADIUS server configured on the system to authenticate clients and has
the L2 Distributed Tunneling Mode enabled.
Note: When L2 Distributed tunneling is enabled, note the following network considerations:
• If APs are located in different subnets, the client VLANs must also be separated by a router so
that the VLANs do not form a single bridge segment.
• If the IP addresses of the APs are on the same subnet, all VLANs used by the wireless clients
must also be located in the same bridge segment.
The Voice network also uses a DiffServ policy to expedite the voice traffic. The policy must already be
configured in order to associate it with the Voice network. You configure the policy by using the pages
available from the LAN > QoS > Differentiated Services folder. For information about configuring DiffServ
policies, see "Configuring Differentiated Services for VoIP" on page
1. Access the WLAN > Administration > Basic Setup page, and then click the SSID tab.
By default, Network 1 is enabled and uses "Guest Network" as the SSID.
2. Configure the first VAP.
a. Click Edit for Network 1 to access the Wireless Network Configuration page for that network.
b. Delete the existing SSID and enter Visitor in the SSID field.
c. In the VLAN field, enter 10.
D-Link
Oct. 2015

Table 387: VAP Configuration Example Settings

Security
None
WPA Personal
WPA Enterprise
Redirect
http://www.dlink.com.tw
None
None
694.
Unified Wired and Wireless Access System
Configuring a Virtual Access Point
Client QoS
http://
www.dlink.com.tw
Bandwidth Restrictions
None
DiffServ Policy Up
Page 690