Configuring A Secondary Vrrp Address - D-Link DWL-8600AP User Manual

D-Link UWS User Manual
Field
Configured Priority
Priority
Advertisement Interval (secs) Enter the time, in seconds, between the transmission of advertisement
Interface IP Address
IP Address
Authentication Type
Authentication Data
Status
Command Buttons
• Click Submit to apply the new configuration and cause the change to take effect. These changes will not
be retained across a power cycle unless a Save configuration is performed.
• Click Secondary IP Address to proceed to the Secondary IP Address configuration page.
• Click Delete to delete the selected Virtual Router. Note that the router cannot be deleted if there are
secondary addresses configured.
• Click Track Interface to proceed to the VRRP Track Interface configuration page.
• Click Track Route to proceed to the VRRP Track Route configuration page.

Configuring a Secondary VRRP Address

To configure a secondary VRRP address, first configure one IP address (the primary address) for the VR. Then,
you can add multiple secondary addresses to that interface.
• Click Submit to apply the new configuration and cause the change to take effect. These changes will not
be retained across a power cycle unless a Save configuration is performed.
• Click Delete to delete the selected secondary IP address.
• Click Cancel to return to the Virtual Router Configuration page.
D-Link
Oct. 2015
Table 192: Virtual Router Configuration Fields (Cont.)
Description
Enter the priority value to be used by the VRRP router in the election for the
master virtual router. If the Virtual IP Address is the same as the interface IP
Address, the priority gets set to 255 no matter what you enter. If you enter a
priority of 255 when the Virtual and interface IP Addresses are not the same,
the priority gets set to the default value of 100.
The operational priority of the VRRP router. This is relative to the configured
priority. The operational priority depends upon the configured priority, and
the priority decrements configured through the tracking process.
packets by this virtual router. Enter a number between 1 and 255. The default
value is 1 second.
Indicates the IP Address associated with the selected interface.
Enter the IP Address associated with the Virtual Router. The default is 0.0.0.0,
which you must change prior to clicking Create.
Select the type of Authentication for the Virtual Router from the dropdown
menu. The default is None. The choices are:
• 0-None: No authentication is performed.
• 1-Simple: Authentication is performed using a text password.
If you selected simple authentication, enter the password.
Select active or inactive from the dropdown menu to start or stop the
operation of the Virtual Router. The default is inactive.
Virtual Router Redundancy Protocol (VRRP)
Unified Wired and Wireless Access System
Page 326