Table 21: Telnet Session Configuration Fields - D-Link DWL-8600AP User Manual

Dws-4000 series access points

Hide thumbs Also See for DWL-8600AP:

Table of Contents

D-Link UWS User Manual

Telnet Session Timeout

Maximum Number of Telnet

Allow New Telnet Sessions

Telnet Server Admin Mode

• If you change any of the telnet parameters, click Submit to apply the changes to the system. If you want

the switch to retain the new values across a power cycle, you must perform a save.

Table 21: Telnet Session Configuration Fields

Specify how many minutes of inactivity should occur on a telnet session

before the session is logged off. You may enter any number from 1 to 160. The

factory default is 5.

Note: When you change the timeout value, the new value is applied to all

active and inactive sessions immediately. Any sessions that have been idle

longer than the new timeout value are disconnected immediately.

From the drop-down menu, select how many simultaneous telnet sessions to

allow. The maximum is 5, which is also the factory default. A value of 0

indicates that no outbound Telnet session can be established.

Controls whether to allow new telnet sessions:

• Yes: Permits new telnet sessions until the maximum number allowed is

• No: New telnet sessions will not be allowed, but existing sessions are not

disconnected.

Administrative mode for inbound telnet sessions. Setting this value to disable

shuts down the telnet port. If the admin mode is set to disable, then all

existing telnet connections are disconnected. The default value is Enable.

Unified Wired and Wireless Access System

Telnet Sessions

Show Quick Links

Table of Contents