Snmp Trap Configuration; Figure 280: Snmp Trap Configuration; Table 241: Snmp Trap Configuration - D-Link DWL-8600AP User Manual

D-Link UWS User Manual

SNMP Trap Configuration

Use the SNMP Trap Configuration page to configure whether or not SNMP traps are sent from the Captive
Portal and to specify captive portal events that will generate a trap.
Note: You can configure the Captive Portal traps only if the Captive Portal Trap Mode is enabled,
which you configure on the LAN > Administration > SNMP Manager > Trap Flags page.
All CP SNMP traps are disabled by default.
To configure SNMP trap settings for various captive portal features, click Security > Captive Portal > SNMP
Trap Configuration.
The traps specified in the table below are generated only by the Cluster Controller unless otherwise specified.
The following table describes the events that generate SNMP traps when the status is Enabled.
Field
Captive Portal Trap Mode
Client Authentication Failure
Traps
Client Connection Traps
Client Database Full Traps
Client Disconnection Traps
D-Link
Oct. 2015

Figure 280: SNMP Trap Configuration

Table 241: SNMP Trap Configuration

Description
Displays the captive portal trap mode status. To enable or disable the mode,
use Captive Portal menu on the LAN > Administration > SNMP Manager >
Trap Flags page.
If you enable this field, the SNMP agent sends a trap when a client attempts
to authenticate with a captive portal but is unsuccessful.
If you enable this field, the SNMP agent sends a trap when a client
authenticates with and connects to a captive portal.
If you enable this field, the SNMP agent sends a trap each time an entry
cannot be added to the client database because it is full.
If you enable this field, the SNMP agent sends a trap when a client
disconnects from a captive portal.
Captive Portal Configuration
Unified Wired and Wireless Access System
Page 410