Testing The Library Configuration - Quantum Scalar 50 Quick Start Manual

Testing the Library Configuration

Running a Health Check
Figure 39 Overview Page
After you have completed the library installation, you must test the configuration to
ensure proper operation.
Testing the library configuration consists of the following steps:
• Running a Health Check
• Testing a Multiple Library Stack Configuration
0 Running a health check will verify all robotics axis and ensure that the library is operating
normally.
To run a health check:
1 On the host computer, open the internet browser software.
2 In the field, type http://IPaddress/ where IP address is the IP address for the
Address
Quantum Scalar 50.
3 Enter the username and password and click
Note: The default username and password is
The page displays (see
Overview
4 Click the tab.
Utilities
The page displays (see
Utilities
Testing the Library Configuration
Scalar 50 Tape Library
.
OK
.
admin
figure 39):
figure 40).
Utilities tab
39