Table of Contents
Advertisement
Set the delimiter to be sent at the end of the received
data.
"NONE": delimiter is not checked and all received data
DELIMITER
*1 *2
within the set timeout will be valid.
Value other than "NONE": delimiter is checked and
data received before delimiter will be valid.
*1
RCV CHECK
Set whether reply command that may be returned is
*3
checked or not.
Set the timeout time for reply command to a sent
TIME OUT
command.
*1 *4 *5
Set the number of retries to resend the same
*1 *4 *5
RETRY
command again if no valid response is replied.
Set the retry interval to resend the command.
*1 *4 *5
INTERVAL
Set whether the next command is to be executed or
*1 *4 *5
ERROR
not if no valid response is replied, even after
completing retry for the set number of retries.
HDMI CEC
Set the CEC control for display devices connected to
*9
control
OUT1A to OUT4A.
Set the CEC control for display devices connected to
HDBaseT CEC
OUT1B to OUT4B.
Set whether the next command is executed or not if no
Process for CEC
response is replied from the display device that is
*9
error
controlled with CEC.
Register a note up to 14 characters.
MEMO
The registered note is displayed when the control
command is executed.
1
If "Port" is set to "CEC", you do not need to set this item.
*
2
If "RECV DISPLAY" is set to "OFF", you do not need to set this item.
*
3
If "RECV DISPLAY" is set to "ASCII" or "HEX", you do not need to set this item.
*
4
If only "LOOP BACK" of communication ports is set to "ON", you do not need to set this item.
*
5
If all "RCV CHECK" is set to "NOT CHECK", you do not need to set this item.
*
6
If either "RS-1" or "RS-2" is set to "ON", set "7.10.2 RS-232C operation mode [FUNCTION]" to
*
"TRANSMITTER". The mode of OUT1B RS to OUT4B RS is fixed at "TRANSMITTER", no menu is
displayed.
7
*
OUT1B to OUT4B are available only if HDBaseT output option is mounted.
8
If any LAN connections for "LAN1" to "LAN8" are set to "ON", set "7.11.4 LAN operation mode
*
[FUNCTION]" to "TRANSMITTER".
9
If "PORT" is set to "COM", you do not need to set this item.
*
153
MSD-804FD User's Guide
NONE [Default]
00 to FF (Hex)
CHECK [Default]
NOT CHECK
0 ms. to 99 seconds and 999
ms.
[Default]: 0 ms.
0 to 99
[Default]: 0
0 ms. to 99 seconds and 999
ms.
[Default]: 0 ms.
STOP: [Default]
EXEC: Continue
-: Not control [Default]
POWER OFF
POWER ON
-: Not control [Default]
POWER OFF
POWER ON
STOP [Default]
EXEC: Continue
20 to 7D of ASCII codes
except for 2C (,)
[Default]: All spaces
Advertisement
Table of Contents
