Table of Contents
Advertisement
Problem
"RETRY OVER
ERROR" is displayed
and control command
is not sent completely.
Control through CEC
cannot be performed.
Others
Input signals
temporarily
disappear when input
channel is switched.
Devices cannot be
controlled through
CEC.
Cause/Check item/Solution
Is the registered reply command correct?
Make sure that the setting of "TIME OUT" for checking control
commands is not too short.
Do you use cables supporting CEC?
For CEC control, an HDMI cable supporting CEC is required.
Does the display device support CEC? Is the HDMI association
function of the display device set correctly?
Enable the HDMI link control and Power on association function (for
turning on the display device by external devices) of the display
device.
When the CEC connection changes, EDID may change. In this case,
input signals are interrupted. Check the connection settings.
Are HDMI cables supporting CEC being used?
To use CEC, enable HDMI link control of the connected devices
(such as LCD TVs, Blu-ray recorder, and so on).
230
MSD-804FD User's Guide
Page
163
152
163
106
106
Advertisement
Table of Contents
