IDK msd-804fd User Manual page 198

[BLOCK]
[BITMAP1 BLOCK]
0- 63( 23) 0- 63
① ② ③ ④ ⑤
① Current block position
② Current end block position
③ End block position of registered bitmap
④ Start block position after divide
⑤ End block position after divide
*1 The memory area is controlled by 1 block (=65,536 bytes) and end block position or size
of the bitmap is rounded up by 1 block.
*2 The size can be specified directly.
⑨
[BITMAP2 BLOCK]S
64-127(120) 60-103
In case the total number of blocks exceeds 128 as a result of setting the size
manually, a message shown right is displayed when you press the "SET" key and
the setting cannot be applied.
2. To divide memory area using commands:
@SBD: Set bitmap memory divide
@GBD: Get bitmap memory divide
@GBV Get bitmap memory usage
*1
*2
⑩
⑨ In case bitmap is deleted because of changing start
position of memory area, an "S" is displayed.
⑩ In case bitmap will be deleted because of changing
[BITMAP2 BLOCK] E
end position of the memory area, an "E" is displayed.
64-127(120) 64-110
[Fig. 7.47] "BLOCK" and "BYTE"
[BYTE]
[BITMAP1 SIZE]
4194(1572)KB 4194KB
⑥ ⑦ ⑧
⑥ Current memory size
⑦ Memory size of registered bitmap
⑧ Memory size after divide
198
MSD-804FD User's Guide
*1
※2
MEMORY SIZE OVER