Table of Contents
Advertisement
7.9.4
Deep Color [DEEP COLOR INPUT]
This menu is valid only all conditions below are met: if you select "INTERNAL EDID" for "7.9.1 EDID setting
[EDID DATA]", you select a resolution other than "UNUSED" for "7.9.3 Input resolution for AV devices [AV
RESOLUTION]", and you connect an HDMI device such as a Blu-ray recorder.
If you select "30-BIT COLOR" in this menu setting and a display device supporting Deep Color is connected,
the Deep Color is used. However, compared to "24-BIT COLOR", "30-BIT COLOR" is transmitted using a
higher clock frequency, which may cause noise if a cable with a bad quality or a long cable is connected. In
such a case, the noise may be removed by setting the color to "24-BIT COLOR".
･24-BIT COLOR [Default]
･30-BIT COLOR
1. To set the Deep Color using menu:
MSD-804FD
↓ SET key
[FUNCTION SELECT]
EDID
↓ SET key
[EDID]
DEEP COLOR INPUT
↓ SET key
[IN1 DEEP COLOR]
24-BIT COLOR
↓ SET key: Applies settings.
[DEEP COLOR INPUT]
NOW UPDATE...
↓
[EDID]
DEEP COLOR INPUT
Note:
If you do not press the "SET" key, Deep Color is not changed. Make sure to press the "SET" key.
2. To set the Deep Color using commands:
@SDI: Set Deep Color
@GDI: Get Deep Color
Top
▲▼keys: Select "EDID".
▲▼keys: Select "DEEP COLOR INPUT".
▲▼keys: Select the desired color depth (24-BIT COLOR or 30-BIT
COLOR).
◄►keys: Select the desired input (IN1 to IN8).
The message is displayed for one second and then previous screen is
displayed automatically.
128
MSD-804FD User's Guide
For each input
Advertisement
Table of Contents
