Loading Cross Point; Locking/Unlocking Front Keys - IDK msd-804fd User Manual

6.5

Loading cross point

You can register up to eight cross points in the MSD, but the MSD can only load cross points 1 to 5 by cross
point load keys. To load cross points 6 to 8, use menu settings in the "Load cross point" section ("7.13.1
Loading cross point [LOAD CROSS POINT]") or use RS-232C, or LAN.
Since nothing is registered by factory default, cross point is not valid until they are registered. To load them,
register cross points in advance.
Command control:
▪ Loading V&A input selection setting from cross point memory: @RCM
▪ Loading video input selection setting from cross point memory: @RCV
▪ Loading audio input selection setting from cross point memory: @RCA
Step 1.
Select "PRESET LOAD" using the Operation Mode selection key.
Step 2.
Press the cross point command keys to load the cross point settings.
Commands A to E correspond to cross points 1 to 5.
DIGITAL
DISPLAY
POWER
MULTI
SWITCHER
1
2
POWER
3
ON
OFF
4
6.6

Locking/unlocking front keys

To lock the front panel keys, press and hold the Operation Mode selection key for 2 seconds or longer until
hearing the buzzer sound. To release the key lock, do the same operation again. When the setting is changed,
the status will be displayed for 1 second.
。
KEY LOCK !
Locked
Command control: Setting and releasing key lock: @SLS/@GLS
IN1 IN2 IN3 IN4 IN5
[Fig. 6.5] Loading cross point
KEY LOCK RELEASE !
Unlocked
IN6 IN7 IN8 OFF
OUT1
OUT2
OUT3
OUT4
Operation mode selection keys
29
MSD-804FD User's Guide
MSD-804FD
COMMAND COMMAND COMMAND COMMAND COMMAND
A B C D E
M ENU/SET
COM MA ND
PRESET L OAD
ESC
SWITCHING MODE
V&A VIDEO A UDIO
Cross point load key