Table of Contents
Advertisement
[Step I-iv. Reply command]
RCV 1:
NOT CHECK
↓◄►keys
RCV 2:
NOT CHECK
◄►keys
RCV32:NG
NOT CHECK
↓◄►keys
Go to step I-v below to continue.
[Step I-v. Setting timeout]
TIME OUT: 0s000ms
RETRY: 0
↓◄►keys
TIME OUT: 0s000ms
RETRY: 0
↓◄►keys
TIME OUT: 0s000ms
RETRY:
0
↓◄►keys
INTERVAL: 0s000ms
ERROR:STOP
↓◄►keys
INTERVAL: 0s000ms
ERROR:STOP
↓◄►keys
INTERVAL: 0s000ms
ERROR:STOP
↓◄►keys
MEMO:
1
↓ SET key: Applies settings.
[PRESET COMMAND 1]
NOW UPDATE...
↓
[COMMAND EDIT]
CMD
1
*5
The numbers at the lower left indicate the number of characters of the cursor position.
Note:
If you do not press the "SET" key, the control command is not changed. Make sure to press the "SET" key.
▲▼keys: Set whether to check reply command 1 (NOT CHECK,
CHECK). Memo is displayed at the right of the command number.
▲▼keys: Set whether to check reply command 2. (NOT CHECK,
CHECK). Memo is displayed at the right of the command number.
▲▼keys: Set whether to check reply command 32 (NOT CHECK,
CHECK). Memo is displayed at the right of the command number.
▲▼keys: Set the retry timeout in seconds (0 to 99).
▲▼keys: Set the retry timeout in milliseconds (0 to 999).
▲▼keys: Set the number of retries (0 to 99).
▲▼keys: Set the retry interval in seconds (0 to 99).
▲▼keys: Set the retry interval in milliseconds (0 to 999).
▲▼keys: Select the action for when retry over occurs (STOP, EXEC).
▲▼keys: Set the "MEMO" (20 to 7D of ASCII codes except for 2C).
◄►keys: Moves the cursor to the next number (Up to 14 characters).
The message is displayed for one second and then previous screen is
displayed automatically.
157
MSD-804FD User's Guide
*5
Advertisement
Table of Contents
