Window Transition Speed [Switching Speed] - IDK msd-804fd User Manual

7.7.6

Window transition speed [SWITCHING SPEED]

You can set the window transition speed for "FADE OUT-IN", "DISSOLVE", or "WIPE OUT/IN" when input
channel is switched.
These options are not available when "7.7.5 Window transition effect [VIDEO SWITCHING]" is set to
"CUT".
･100 ms. (0.1 seconds) to 2000 ms. (2.0 seconds) by 10 ms. [Default]: 350 ms. (0.35 seconds)
Video output
Vertical synchronous
Note:
Setting of this menu is applied not only when input is switched but also when "7.5.4 Automatic detection of
input video interruption [INPUT OFF CHECK]" is set to "ON".
Since "FADE OUT-IN", "DISSOLVE", and WIPE IN/OUT are performed after synchronization to vertical
synchronous signals of the output, the actual speed may be a few milliseconds slower or faster than the set
time. For example, if the output resolution is 1080p@60, the set switching speed of video inputs is 420 ms.,
and "FADE OUT-IN", "DISSOLVE", or WIPE IN/OUT is performed at 0.42 (second) × 60 (frame/second) ≒ 25
frames, the actual speed becomes 25 (frames) ÷ 60 (frame/second) ≒ 0.4166 seconds ≒ approximately
416.6 ms.
1. To set the switching speed using menu:
MSD-804FD
↓ SET key
[FUNCTION SELECT]
OUTPUT SETTING
↓ SET key
[OUTPUT SETTING]
SWITCHING SPEED
↓ SET key
[OUT1 FADE SPEED]
350ms
↓ ESC key: Returns to the previous screen.
2. To set the window transition speed using commands:
@SFT: Set video switching speed
@GFT: Get video switching speed
Input channel is
switched
ON
OFF
signals
Fade-out starts
(a) Speed of switching video input channel
(b) Waiting time before video becomes stable (approx. 5 frames)
(c) Speed of switching video input channel
[Fig. 7.24] FADE OUT/IN
Top
▲▼keys: Select "OUTPUT SETTING".
▲▼keys: Select "SWITCHING SPEED".
▲▼keys: Set the switching speed (100 ms. to 2000 ms.).
◄►keys: Select the desired output (OUT1 to OUT4).
For each output (common to OUTA and OUTB)
Fade-in starts Fade-in ends
(a) (b) (c)
Fade-out ends
100
MSD-804FD User's Guide
Time