Temperature Sensor Assembly; Heater Rod - Star Micronics LS-5 SERIES Technical Manual

REPLACEMENT AND ADJUSTMENTS OF PARTS

4-5. Temperature Sensor Assembly

(1) Remove the following units:
• Exit chute (according to the procedure described
in section 4-3)
• Screw [1]
• Two screws [2]
• Three screws [3]
• Ground plate [4]
• Temperature sensor assembly [5]
Caution when disassembling:
When removing temperature sensor assembly [5], be care-
ful not to scratch the heat roller [6].
Caution when assembling:
Attach the temperature sensor assembly [5] so that its
thermistor is positioned underneath the heat roller [6].
Connect harnesses [7], [8], and [9] coming from the con-
nector (J101) of the temperature sensor assembly [5] to the
positions shown in the diagram.
J101-5PIN [7]
J101-2PIN (100/115 VAC) [8]
J101-3PIN (220/240 VAC) [8]
J101-6PIN [9]

4-6. Heater Rod

(1) Remove the following units:
• Pressure roll (according to the procedure
described in section 4-2)
• Two screws [1]
• Screw [2]
• Fuser frame R [3]
Caution when disassembling:
Support the heater rod [4] when removing the
fuser frame R [3].
• Idler shaft [5]
• Gear idler [6]
• Screw [7]
• Heater rod [4]
– 43 –