Xerox WorkCentre 5945 User's Manual And Warranty page 90

Copy
Use the stapling options to staple your document. The options available are dependent on the
finishing device installed. The basic stapling options are Off, 1 Staple and 2 Staples.
• If required, select the Off button to cancel any programming you have entered.
• 1 Staple positions a single staple the top left corner of your document.
• 2 Staples positions 2 staples along the trail edge of your document.
Note: For some staple selections the device will rotate the image. If you are unable to staple,
ensure that Image Rotation is set to Auto Rotate in Tools. Your System Administrator sets the
Image Rotation options when the device is installed.
Note: SEF is Short Edge Feed (where the short edge of the paper is the leading edge when the
paper is fed into the device). LEF is Long Edge Feed (where the paper is oriented so that the long
edge is fed into the device first).
7. Select the OK button.
8. Enter the number of prints required using the numeric keypad on the control panel.
9. Press the Start button on the control panel to scan the original.
10. Remove the original from the document feeder or document glass when scanning has
completed. The job enters the job list ready for processing.
11. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
12. If your job remains held in the Active Jobs list, the device needs you to supply additional
resources, such as paper or staples before it can complete the job. To find out what resources
are needed, select the job and then select the Details button. Once the resources are available
the job will print.
More Information
Using the None Output Option for Copies
Collating Copies
Hole Punching Copies
Preparing Copies to be made into a Booklet
Using a User ID to Log In at the Device
Using Internet Services to find System Administrator Contact Details
Viewing the Progress and Details of a Job using the Job Status Menu
Hole Punching Copies
When you press the Start button to make a copy, the device scans your originals and temporarily
stores the images. It then prints the images based on the selections made.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Copy features.
Depending on the optional finishing device and kits installed you will have the choice of different
output options such as stapling, folding and collating.
Use the Hole Punched / Stapled option if you want your output to be hole punched or hole punched
and stapled. Each sheet will be punched individually so there is no limit to the number of pages you
can have in a set. Hole punching can only be selected for A4 LEF (8.5 x 11" LEF) and A3 (11 x 17")
paper.
Note: The Collation options must be set before selecting the Hole Punched / Stapled options.
88
®
WorkCentre 5945/5955
User Guide