Xerox WorkCentre 5945 User's Manual And Warranty page 149

Fax
6. Select the Enter Fax Number entry box and use the numeric keypad, or the touch screen
keypad to enter the recipient's fax number.
7. Select the Add button.
• If you want to send the document to more than one recipient enter the additional details,
one recipient at a time, and select the Add button again until all the recipients have been
added.
8. Select the Close button to save the information you entered.
9. Select the Image Quality tab.
10. Select the Image Enhancement button.
11. Select Auto Suppression from the Background Suppression menu to automatically suppress
unwanted background.
• If required, select Off to turn the Background Suppression feature off. The Off option is
particularly useful when the Darken adjustment does not produce a satisfactory output
from light originals, the original has a gray or colored border, such as a certificate, or you
want to bring out fine detail that was lost due to a dark edge when using bound originals.
12. Select the OK button.
13. Press the Start button on the control panel to scan the original.
14. Remove the original from the document feeder or document glass when scanning has
completed.
15. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
More Information
Choosing an Image Enhancement Option for Faxes (Embedded Fax)
Setting the Fax Contrast (Embedded Fax)
Using a User ID to Log In at the Device
Lightening or Darkening Faxes (Embedded Fax)
Explaining the Fax Options
Using Internet Services to find System Administrator Contact Details
System Administrator Guide
Setting the Fax Contrast (Embedded Fax)
Use the Fax (Embedded Fax) service to scan your documents and send them to most types of fax
machines that are connected to the telephone network.
Note: This option must be made available by your System Administrator.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Fax features.
Use the Contrast option to control the image density on the output and compensate for an original
that has too much or too little contrast on the image.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
User Guide
www.xerox.com/support.
®
WorkCentre 5945/5955
147