Xerox WorkCentre 5945 User's Manual And Warranty page 685

General Care and Troubleshooting
7. Close the finisher door.
Booklet Maker Cartridges
Note: If you experience difficulty performing this task, it may be necessary to request a service
engineer to perform it for you.
1. Open the finisher front door.
2. Locate the staple cartridges. These are in the upper left part of the cavity at the bottom of the
unit.
3. Remove each staple cartridge individually by pulling the orange handle upwards.
4. Check you have removed the paper tab from the new staple cartridge.
5. Insert the new cartridges one at a time by pushing each up and then to the left (almost in a
clockwise motion) until the cartridge clicks into place.
6. Close the finisher door.
More Information
Replacing the Staple Cartridge in the Office Finisher
Replacing the Staple Cartridge in the Convenience Stapler
Getting Further Assistance
Replacing the Staple Cartridge in the Convenience Stapler
1. Lift the orange handle on the back of the convenience stapler. This will raise the back of the
unit and expose the staple cartridge.
2. Grasp the cartridge by the orange handle and pull it out of the device.
3. Check you have removed the paper tab from the new staple cartridge.
4. Install the replacement staple cartridge.
5. Push the orange handle on the back of the convenience stapler to return the device to the
original position.
Note: For more detailed instructions see the device touch screen or the instructions provided
with the new staples.
More Information
Replacing the Staple Cartridge in the Office Finisher
Replacing the Staple Cartridges in the New Office Finisher Booklet Maker
Emptying the Hole Punch Waste
The hole punch waste container is a catch tray that collects the waste punched paper. Your device
will prompt you when the hole punch waste container needs emptying.
This finisher and some of its' components are optional and may not be fitted to your device.
1. Open the finisher front door.
2. Locate the hole punch waste container. It is at the top of the device, near label 5a.
3. Grasp the orange handle and pull the waste container straight out of the finisher.
4. Dispose of the waste punched paper in the waste bin.
5. Re-insert the waste container and push it gently into the device as far as it can go.
User Guide
®
WorkCentre 5945/5955
683