Specifying The Size Of The Original To Be Copied - Xerox WorkCentre 5945 User's Manual And Warranty

Copy
More Information
Using a User ID to Log In at the Device
Viewing the Progress and Details of a Job using the Job Status Menu

Specifying the Size of the Original to be Copied

When you press the Start button to make a copy, the device scans your originals and temporarily
stores the images. It then prints the images based on the selections made.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Copy features.
Use the Original Size options to select automatic size detection of the originals, specify the sizes of
mixed size originals, or specify the exact size of an image to be scanned.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
4. Select the Copy button on the touch screen. The copy features are displayed.
5. Select the Layout Adjustment tab.
6. Select the Original Size button.
7. Select the Original Size option required.
• Auto Detect enables automatic size sensing, this is the default setting. The size detected
is matched to a standard paper size.
• Preset Scan Area defines the size of your original from a list of preset, standard original
sizes. You can view the list by using the scroll bar.
• Custom Scan Area sets a specific area for scanning and is useful for scanning receipts.
Measure the width (X) and height (Y) of the original to be scanned and enter the X and Y
measurements into the fields provided.
• Mixed Size Originals scans documents containing different sized pages. The pages must
be the same width, such as A4 (8.5 x 11") LEF and A3 (11 x 17") SEF, other combinations
are shown on the device touchscreen. The device detects the size of the documents and
will produce different output depending on the combinations selected.
Note: If Auto Reduce / Enlarge and a specific Paper Supply is selected, all the images are
reduced or enlarged to fit the specified paper size. If Auto Paper supply is selected a mixture of
paper sizes will be output.
Note: SEF is Short Edge Feed (where the short edge of the paper is the leading edge when the
paper is fed into the device). LEF is Long Edge Feed (where the paper is oriented so that the long
edge is fed into the device first).
8. Select the OK button.
9. Enter the number of prints required using the numeric keypad on the control panel.
10. Press the Start button on the control panel to scan the original.
11. Remove the original from the document feeder or document glass when scanning has
completed. The job enters the job list ready for processing.
100
®
WorkCentre 5945/5955
User Guide