Projector Led Status Indicators; Work With The Lamp; Turning The Lamp On; Turn The Lamp Off - Christie D4K25 User Manual

Section 5: Projector Operation
5.4

Projector LED Status Indicators

Red, yellow, and green LEDs on the top and rear corners of the projector indicate the status of the projector.
The LEDs can be solidly lit, or they can flash frequently or intermittently. This table lists the LED state and its
associated meaning.
Table 5.1 Projector Status LED Legend
LED
Solid Green
Green Blip
Solid Yellow
Yellow Blip/
Green Blip
Flashing Red
Solid Red
5.5

Work with the Lamp

This section provides information and procedures for optimizing lamp performance. Optimizing lamp
performance can ensure you receive the brightest, most uniform image possible for the life of the lamp.

5.5.1 Turning the Lamp On

1. Turn on the circuit breaker for the projector.
2. On the Touch Pad Controller (TPC) press and hold the green power icon for two seconds.
3. On the TPC, press and hold the lamp on icon for 2 seconds.

5.5.2 Turn the Lamp Off

1. On the Touch Pad Controller (TPC), press and hold the lamp off icon for two seconds.
2. On the TPC, press and hold the power off icon for two seconds.
3. Disconnect the projector from AC power and turn the projector circuit breaker off.

5.5.3 Adjust Lamp Power

1. Tap Menu > Advanced Setup > Lamp Power/LiteLOC Setup
2. Increase or decrease the Power% value.
3. Tap Set Target.
4. Select Enable LiteLOC™.
5-2
State
Lamp ON
Power ON
Standby mode
Cool down mode
New critical alarm or warning
Existing critical alarm or warning
Description
Power is ON, Lamp is ON.
Power is ON, Lamp is OFF. The lamp can be struck when in
this mode.
Power is OFF, Lamp is OFF. Power saving mode.
Transition to STANDBY mode.
Power is ON, Lamp is OFF.
The lamp can be struck when in this mode.
New critical alarm or warning has NOT been acknowledged
by operator.
Critical alarm or warning exists, but has been acknowledged
by operator.
D4K25 User Manual
020-100882-02 Rev. 1 (07-2012)