Adding The Lamp Information To The Lamp History; Turning The Lamp On; Aligning The Lamp - Christie CP2208 Installation And Setup Manual

Field
Download MIB to USB
Apply
Serial Access
Ethernet Access

Adding the lamp information to the lamp history

1. If the lamp is on, tap the lamp off (
2. Tap Menu > Advanced Setup > Lamp Change Wizard.
3. Tap Next.
4. Complete these fields:
Field
Type
Serial Number
Reason for Change
Lamp Expiry (Hours)
Hours Used
5. Tap Save.
6. Tap Next.

Turning the lamp on

On the projector touch panel controller (TPC) tap the lamp on (

Aligning the lamp

1. Tap Menu > Advanced Setup > Lamp Power.
2. Verify the value in the Power% field is at a level suitable for your requirements.
3. Tap Menu > Advanced Setup > Light Adjust.
4. Record the number in the Intensity field.
5. Tap Display Full Screen White Test Pattern.
CP2208 Installation and Setup Guide
020-102031-01 Rev. 1 (09-2015)
Description
Sends the SNMP Management Information Base (MIB) file to a USB flash
drive.
Applies SNMP settings.
Grants access to serial connections.
Grants access to Ethernet connections.
) icon to turn it off.
Description
The lamp type.
The lamp serial number.
The reason the lamp was changed.
The number of hours the lamp can operate before replacement.
This field is auto-populated.
The number of hours the lamp has operated before installation.
) icon.
23