Table of Contents
Advertisement
Managing the lamp
Optimizing lamp performance can make sure you receive the brightest, most uniform image possible
for the life of the lamp.
Only applies to: CP2415-Xe, CP2420-Xe, CP4420-Xe
For more information on Christie Xenolite
cinema/cinema-lamps/.
Turning the lamp on
Learn how to turn the lamp on.
Do not attempt operation if the AC supply is outside the specified voltage range.
1. Turn on the circuit breaker for the projector.
2. Select and hold Power for two seconds.
3. Select and hold Lamp On for two seconds.
Turning the lamp off
Learn how to turn the lamp and projector off.
1. Select and hold Lamp Off for two seconds.
2. Select and hold Power Off for two seconds.
3. Wait for the lamp to cool down and then disconnect the projector from AC power and turn off
the circuit breaker for the projector.
Adjusting the lamp power
Learn how to adjust the lamp power.
1. In the left navigation menu, select Lamp Settings > Lamp Power/LiteLOC Setup.
2. Increase or decrease the Power % value.
3. Select Set Target.
4. Select Enable LiteLOC.
Changing the lamp power percentage
Learn how to change the lamp power percentage.
Entering a new Lamp Power percentage temporarily disables LiteLOC
1. In the left navigation menu, select Lamp Settings > Lamp Power/LiteLOC Setup.
CineLife+ User Guide
020-103073-10 Rev. 1 (02-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
®
lamps, refer to https://www.christiedigital.com/products/
™
settings.
58
Advertisement
Table of Contents
