Turning The Lamp On; Aligning The Lamp; Adjusting The Image To Fit The Screen - Christie CP2208 User Manual

Turning the lamp on

To complete the remaining setup procedures, turn the lamp on.
On the projector touch panel controller (TPC), tap Lamp On.

Aligning the lamp

Complete the following procedure to align the lamp.
1. Complete a coarse lamp adjustment.
a) Locate the Y axis adjustment label on the operator side of the projector
b) Insert a 5 mm hex driver through the louvers at an angle below the Y axis adjustment
label until it is firmly seated on the Y axis adjustment screw.
c) Turn the screw clockwise or counterclockwise until the value in the Intensity field peaks
and then reduces.
d) Remove the hex driver and repeat steps a to c to adjust the Z and X axis.
2. Complete a fine lamp adjustment.
a) Locate the Y axis adjustment label on the operator side of the projector.
b) Insert a 5 mm hex driver through the louvers at an angle below the Y axis adjustment
label until it is firmly seated on the Y axis adjustment screw.
c) Turn the screw slowly clockwise or counterclockwise until you determine the highest value.
d) Remove the hex driver and repeat steps a to c to adjust the Z and X axis.

Adjusting the image to fit the screen

This procedure must be completed before you complete a boresight adjustment.
1. Verify that the projector is properly positioned relative to the screen (on page 13).
2. Display the RGB-12bit-Full Screen White test pattern (on page 66).
CP2208 User Guide
020-101916-03 Rev. 1 (12-20120)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Installing and setting up
24