Snmp Trap Destination Cli Commands - Quantum DXi4500 Manual

SNMP Trap Destination
CLI Commands
Other System Configuration CLI Commands
On Demand E-mail Home Status
syscli --send statusondemand [--emailaddr <recipient_email_address>]
This CLI command allows the admin user to send the e-mail containing Status
information, on demand.
On Demand E-mail Home Configuration
syscli --send configondemand --emailaddr <recipient_email_address>
This CLI command allows the admin user to send the e-mail containing Status
information, on demand.
The following SNMP trap destination CLI commands are available:
• Listing SNMP Trap Destinations
• Adding SNMP Trap Destinations
• Editing SNMP Trap Destinations
• Deleting SNMP Trap Destinations
• Deleting All SNMP Trap Destinations
• Listing the SNMP Community
• Adding an SNMP Community
• Editing an SNMP Community
• Deleting an SNMP Community
• Deleting All SNMP Communities
• Sending a Test Trap
Listing SNMP Trap Destinations
syscli --list snmptrapdest
This CLI command allows the user to list the configured SNMP trap destinations.
An example output of Trap Destination is shown below.
Total TrapDestinations = 2
Trap Destination number = 1
IP Address = 10.40.166.87
Name = public
Selected Traps =
Failure,Warning,Informational,Available,Unavailable
Trap Destination number = 2
IP Address = 10.40.167.77
Name = public
Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-02 Rev A
July 2011
63