Before You Begin The Installation; Tools Required - Sun Microsystems Fire 280R Setup And Rackmounting Manual

Hide thumbs Also See for Fire 280R:

Table of Contents

Before You Begin the Installation

Unpack the system and verify the contents. See Chapter 1 for instructions.

Unpack the accessory box and place the assembled slides and hardware on a clear

work surface.

Verify that you have the components and hardware shown in "Accessory and

Slide Assembly Box Contents" on page 3.

Read the rack enclosure requirements described in Appendix A of this guide to

ensure that you meet the enclosure requirements.

Read the safety precautions that follow the "Tools Required" section.

For faster installation and setup, use two sets of the required tools. Two persons

are required to install the server.

Phillips No. 2 screwdriver

Flat-blade screwdriver

Set of appropriate Allen wrenches to remove the side panels on some rack

enclosures

Adjustable wrench to tighten the nuts on the mounting brackets

Spirit level for leveling the rackmount enclosure front-to-back and

side-to-side (if necessary)

Sun Fire 280R Server Setup and Rackmounting Guide • January 2001

Table of Contents

Do you have a question about the Fire 280R and is the answer not in the manual?