Setting Ink - MIMAKI Tx300P-1800 Operation Manual

Setting Ink

Take out the 2L ink pack.
1
• Take out the 2L ink pack and the IC chip from a
small cardboard box.
IC chip
Mount the IC chip.
2
• Be careful of the IC chip direction. If it is set in the
wrong direction, ink is not supplied properly.
Insert the chip facing the metal
side to the left.
Do not touch the metal part
while inserting. (The IC chip
may be damaged by static
electricity.)
Put the 2L ink pack into the
3
2L eco case.
(1) Open the 2L eco case as shown on the
following.
(1) While pressing
the finger grip,
2L ink pack
IC chip
(2) open to right
and left.
(2) Tear off the seal on the connector of the 2L
ink pack.
• If there is a seal remaining, when remove 2L ink
pack from the pedestal base, there is a possibility
that ink leaks in large quantities. Please be
careful so that there is no seal remaining.
OK
(3) Put the 2L ink pack facing the connector
down, and close the 2L eco case.
groove
part
• When putting the 2L ink pack, shape the pack
referring to the label in the 2L eco case. If
unshaped, you may not use up the ink.
• Before closing the 2L eco case, make sure the
connector of the ink pack is placed on the groove
part of the 2L eco case. If it is not placed on the
groove, it may not supply ink.
• Replace the 2L eco case spout rubber with a new
one if it has deteriorated.(
Attach the 2L eco case to the base.
4
• Ink is supplied to the printer connecting to the 2L
eco case.
• After 1 or 2 minutes, EMPTY lamp on the
connected printer goes out.
Chapter 1 Before Use
Seal remaining
No Good
P.4-26)
1-11
1
2
2
2
5
6