Caution In Handling Of Ink Bottles; Setting Ink Bottles - MIMAKI UJF-7151 plus Operation Manual

Caution in handling of ink bottles

• If you get ink in your eyes, immediately wash your
eyes with a lot of clean running water for at least
15 minutes. In doing so, also wash the eyess to
rinse ink away completely. Then, consult a doctor
as soon as possible.
• Use genuine ink bottles for this machine. This
machine functions by recognizing the genuine ink
bottles. In case of troubles caused by modified ink
bottles or the like, it shall be out of the warranty
even within the warranty period.
• Store the ink bottle in a place not more than 1 m
off the ground. If you store it in a place higher than
1 m, should the ink bottle fall, the cap may come
off, spilling the ink.
• If the ink bottle is moved from a cold place to a
warm place, leave it in the room temperature for
three hours or more before using it.
• Make sure to store ink bottles in a cool and dark
place.
• Store ink bottles and waste ink tank in a place that
is out of the reach of children.
• Some component (photoinitiator) of the ink is toxic
against aquatic organisms. Avoid leakage of it to
natural water system or domestic waste water.
• Before using an ink bottle, be sure to read the
Safety Data Sheet (SDS).
• Request an industrial waste processor for
processing of empty ink bottles.
• Do not shake ink bottles violently. This may result
in ink leakage from the ink bottles.
• Never refill the ink bottles with ink. This may result
in troubles.
MIMAKI will not bear any responsibility for any
damage caused by the use of the ink bottles
refilled with ink.
• Do not touch or stain the contacts of the IC chip.
This may cause damages on printed circuit
boards.
• The shape of an ink bottle installed in the machine
might collapse as shown in the figure on the right.
This is normal, and does not affect the use or
operation of the machine.

Setting ink bottles

1
Take out the ink bottle, and slowly shake it
twenty times and more.
• To prevent ink from leaking when you shake it,
wear gloves and cover the ink bottle cap with a
paper towel etc. Being in that status, slowly shake
it twenty times and more by flowing ink.
• Before shaking it, check that the cap is firmly
closed.
• If you shake it too strong, it may cause ink
leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the
bottle cannot be beaten enough. Tilt the ink bottle
until it becomes vertical.
Cover with paper towel firmly and shake ink slowly
Repeat this
2
Remove the cap of the ink bottle.
Chapter 1 Before Use
1-9
1
2
2
2
2