Sensor (2 X 500-Sheet Tray Transport) Removal - Lexmark MS911 Service Manual

6
Remove the clip (B).
7
Remove the shaft, and then remove the actuator.

Sensor (2 x 500-sheet tray transport) removal

Note: The following procedure begins with the tray 4 sensor. If you are removing the tray 3 sensor, then proceed
directly to step 5.
1
Remove the rear right cover. See
2
Remove the jam access door. See
3
Remove the bottom right cover. See
4
Remove the tray 4 transport assembly. See
"2 x 500-sheet tray rear right cover removal" on page
"2 x 500-sheet tray jam access door removal" on page
"2 x 500-sheet tray bottom right cover removal" on page
"2 x 500-sheet tray 4 transport assembly removal" on page
Repair information
381
4021
376.
375.
377.
378.