Lexmark MS911 Service Manual page 154

Action
Step 5
a
Reseat the cable on the rest of the motors and on the top door switch.
b
Reseat the cables CN3 and CN4 on the controller board.
c
If necessary, reseat all of the junction connectors on the cables.
d
Make sure that the cables do not block the path of moving parts.
e
Check the cables for damage, and replace if necessary.
Does the problem remain?
Induction heater failure service check
Action
Step 1
Enter the Diagnostics menu, and then navigate to:
PRINTER SETUP > Reset Engine Service Error
Does the problem remain?
Step 2
a
Make sure that the induction heater is properly installed.
b
Reseat the induction heater cable.
c
Check the induction heater and its cable for damage, and replace if
necessary. See "Induction heater removal" on page
Does the problem remain?
Step 3
a
Make sure that the induction heater magnetic erase board is properly
installed.
b
Reseat the induction heater magnetic erase board cables.
c
Check the induction heater magnetic erase board and its cables for
damage, and replace if necessary. See
erase board (IHMEB) removal" on page
Does the problem remain?
Step 4
a
Make sure that the induction heater power supply is properly
installed.
b
Reseat the induction heater power supply cables.
c
Check the induction heater power supply and its cables for damage,
and replace if necessary. See
removal" on page 293.
Does the problem remain?
230.
"Induction heater magnetic
291.
"Induction heater power supply (IHPS)
Diagnostic information
154
Yes No
Contact the next level The problem is solved.
of support.
Yes No
Go to step 2. The problem is solved.
Go to step 3. The problem is solved.
Go to step 4. The problem is solved.
Go to step 5. The problem is solved.
4021