Replace [X] Maintenance Kit, 0 Estimated Pages Remain [80.Xy]; Replace Missing Photoconductor [31.Xy]; Replace Missing Waste Toner Bottle [82.Xy]; Replace Missing Cartridge [31.Xy] - Lexmark MS911 Service Manual

Replace [x] maintenance kit, 0 estimated pages remain [80.xy]

The printer is scheduled for maintenance. For more information, go to the Lexmark support Web site at
http://support.lexmark.com

Replace missing photoconductor [31.xy]

Install the missing photoconductor unit to clear the message.

Replace missing waste toner bottle [82.xy]

Install the missing waste toner bottle to clear the message. For more information, see the instruction sheet that came
with the supply.

Replace missing cartridge [31.xy]

Install the missing cartridge to clear the message.
Replace paper pick rollers in [paper source], use parts and instructions in tray 1 or
tray 2 compartment [80]
Try one or more of the following:
•
Replace the pick rollers, and then touch Rollers replaced on the control panel to clear the message and continue
printing.
•
Touch Replace later (jams may persist) to ignore the message and continue printing.

Replace photoconductor, 0 pages remain [84.xy]

Replace the photoconductor unit to clear the message and continue printing.

Replace unsupported cartridge [32.xy]

Remove the toner cartridge, and then install a supported one to clear the message and continue printing. For more
information, see the instruction sheet that came with the supply or see the "Replacing supplies" section of the User's
Guide.
Note: If you do not have a replacement cartridge, then see the "Ordering supplies" section of the User's Guide or
visit www.lexmark.com.

Replace unsupported photoconductor [32.xy]

Remove the photoconductor unit, and then install a supported one to clear the message and continue printing.

Replace waste toner bottle [82.xy]

Replace the waste toner bottle to clear the message.
or contact your service representative, and then report the message.
Diagnostic information
109
4021