Lexmark MS911 Service Manual page 185

4021
Printed Page Count
This setting gauges the amount of usage on the printer. The value of the Printed Page Count setting equals the value
of the Picked Sides meter. After all print tests are completed, the value resets to zero.
Enter the Diagnostics Menu, and then navigate to:
PRINTER SETUP > Printed Page Count
Note: The value of the setting cannot be changed manually.
Permanent Page Count (Perm page count)
This setting indicates the number of pages that are printed. After all print tests are completed, the value resets to zero.
Enter the Diagnostics Menu, and then navigate to:
PRINTER SETUP > Perm Page Count
Note: The Permanent Page Count value cannot be reset.
Processor ID
This setting indicates the ID of the processor on the controller board.
Enter the Diagnostics Menu, and then navigate to:
PRINTER SETUP > Processor ID
Edge to Edge
This setting shifts all four margins to the physical edges of the page. This feature does not work in PPDS emulation.
Enter the Diagnostics Menu, and then navigate to:
PRINTER SETUP > Edge to Edge
Enable Edge to Edge Copy
This setting determines whether the printer accepts the ADF or flatbed edge erase value when performing an ADF or
flatbed copy.
Enter the Diagnostics Menu, and then navigate to:
PRINTER SETUP > Enable Edge to Edge Copy
Parallel Strobe Adjustment (Par 1 Strobe Adj)
This setting adjusts the factory default setting for how long the strobe is sampled to determine that valid data is available
on the parallel port.
Each time the value increases by one, the strobe is sampled 50 nanoseconds longer than the default value. Each time
the value decreases by one, the strobe is sampled 50 nanoseconds less than the default value. The range of values is
between -4 and +6, in increments of one. A value of zero indicates that no change is made from the factory setting.
Enter the Diagnostics Menu, and then navigate to:
PRINTER SETUP > Par 1 Strobe Adj
Service menus
185