Sensor (Tray 1 And 2 Paper Temperature) Removal; Ozone Fan Removal - Lexmark MS911 Service Manual

Sensor (tray 1 and 2 paper temperature) removal

1
Remove the port access door. See
2
Remove the controller board access cover. See
3
Remove the engine board cover. See
4
Remove the scanner interface cable cover. See
5
Remove the upper rear cover. See
6
Open the controller board frame. See
7
Disconnect the cable (A), remove the screw (B), and then remove the cover.
8
Remove the sensor.

Ozone fan removal

1
Remove the port access door. See
2
Remove the controller board access cover. See
3
Remove the engine board cover. See
4
Remove the scanner interface cable cover. See
5
Remove the upper rear cover. See
6
Open the controller board frame. See
7
Disconnect the three cables (A), remove the three screws (B), and then remove the fan and duct.
Note: If an optional tray is included, then remove the bottom screw (C).
"Port access door removal" on page
"Controller board access cover removal" on page
"Engine board cover removal" on page
"Scanner interface cable cover removal" on page
"Upper rear cover removal" on page
"Controller board frame removal" on page
"Port access door removal" on page
"Controller board access cover removal" on page
"Engine board cover removal" on page
"Scanner interface cable cover removal" on page
"Upper rear cover removal" on page
"Controller board frame removal" on page
Repair information
316
228.
289.
289.
305.
228.
289.
289.
305.
4021
287.
286.
287.
286.