Printer Setup - Lexmark MS911 Service Manual

Disk Test/Clean
Warning—Potential Damage: This test destroys all data on the printer hard disk.
This test may run for approximately 1.5 hours depending on the disk size.
1
Enter the Diagnostics Menu, and then navigate to:
DEVICE TESTS > Disk Test/Clean
You cannot cancel the test once it has started.
2
Exit the test.
Flash Test
This test examines the condition of the flash drive.
Warning—Potential Damage: This test destroys all data on the flash drive.
1
Enter the Diagnostics Menu, and then navigate to:
Device Tests > Flash Test
You cannot cancel the test once it has started.
2
Exit the test.
3
Reformat the flash drive using the Flash Format setting in the Utilities menu.

PRINTER SETUP

Defaults
Warning—Potential Damage: Modifying printer setting defaults restores the NVRAM space to its factory settings.
This setting determines whether the printer uses the U.S. or Non-U.S. factory default value for the following settings:
Printer default values
Paper Sizes setting in the General Settings menu
Default Paper Size (paper feeding sources which do not
have hardware size sensing capabilities)
Default Envelope Size (envelope feeding sources which do
not have hardware size sensing capability)
Fax Paper Size
PCL Symbol Set
PPDS Code Page
Universal Units of Measure
1
Enter the Diagnostics Menu, and then navigate to:
PRINTER SETUP > Defaults
2
Select a default value.
3
Apply the changes.
U.S. value
U.S.
Letter
10 Envelope
Letter
PC-8
437
Inches
Service menus
184
Non-U.S. value
Metric
A4
DL Envelope
A4
PC-850
850
Millimeters
4021