Resetting the maintenance counter
Always reset the maintenance counter after installing the maintenance kit.
Note: Once initiated, the operation cannot be canceled.
Page count
Enter the
200K
Diagnostics menu
200K
Diagnostics menu
300K
Configuration menu
600K
Diagnostics menu
720K
Diagnostics menu
Lubrication specification
Lubricate only when parts are replaced or as needed, not on a scheduled basis. Use of lubricants other than those
specified in this service manual can cause premature failure. Some unauthorized lubricants might chemically attack
polycarbonate parts. Use Grease P/N 99A0394 Nyogel 744.
Cleaning printer parts
Cleaning the printer
Note: You may need to perform this task after every few months.
Warning—Potential Damage: Damage to the printer caused by improper handling is not covered by the printer
warranty.
1
Make sure that the printer is turned off and unplugged from the electrical outlet.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock when cleaning the exterior of the printer,
unplug the power cord from the electrical outlet and disconnect all cables from the printer before
proceeding.
2
Remove paper from the standard bin and multipurpose feeder.
3
Remove any dust, lint, and pieces of paper around the printer using a soft brush or vacuum.
4
Dampen a clean, lint-free cloth with water, and use it to wipe the outside of the printer.
Warning—Potential Damage: Do not use household cleaners or detergents to prevent damage to the exterior
of the printer.
5
Make sure all areas of the printer are dry before sending a new print job.
Navigate to
Reset Separator Roll and Pick Assembly Counter > Reset Separator Roll and Pick
Assembly Counter
Reset Maintenance Counter > Reset 200K Maintenance Kit
Reset Maintenance Counter > Reset 300K Maintenance Kit
Reset Maintenance Counter > Reset 600K Maintenance Kit
Reset Fuser Counter > Reset Fuser Kit
Maintenance
421
4021