Actions
Step 9
Replace the sensor (fusing speed). See
on page
267.
Does the problem remain?
Step 10
a
Make sure that the fuser and its cable are properly connected.
b
Check the fuser for damage, and replace if necessary. See
removal" on page
230.
Does the problem remain?
Skewed print check
Actions
Step 1
Make sure that the following parts are properly installed:
•
Printhead
•
Transfer belt
•
Developer unit
•
Photoconductor
Does the problem remain?
Step 2
Enter the Diagnostics menu, and then navigate to:
REGISTRATION > [source tray] > Print Quick Test
Does the problem remain?
Step 3
Check the registration roller for wear or damage, and replace if necessary.
Does the problem remain?
"Sensor (fusing speed) removal"
"Fuser
Diagnostic information
48
Yes
No
Go to step 10.
The problem is solved.
Contact the next level
The problem is solved.
of support.
Yes
No
Go to step 2.
The problem is solved.
Go to step 3.
The problem is solved.
Go to step 4.
The problem is solved.
4021