Main Drive Assembly Removal - Lexmark MS911 Service Manual

Main drive assembly removal

1
Remove the port access door. See
2
Remove the controller board access cover. See
3
Remove the engine board cover. See
4
Remove the scanner interface cable cover. See
5
Remove the upper rear cover. See
6
Open the controller board frame. See
7
Disconnect the cable (A), remove the four screws (B), and then remove the bracket.
8
Remove the two screws (C), and then disconnect the two cables (D).
Note: We recommend using long nose pliers to disconnect the cables.
"Port access door removal" on page
"Controller board access cover removal" on page
"Engine board cover removal" on page
"Scanner interface cable cover removal" on page
"Upper rear cover removal" on page
"Controller board frame removal" on page
Repair information
319
228.
289.
289.
305.
4021
287.
286.