Controller Software Recovery Update - imagistics ipc1-im8130 Administrator's Manual

110

Controller Software Recovery Update

Replaces the operating system (OS) software and the controller
software from the bootable ipc1-im8130.
There are two ways to update the operating system:
Boot the ipc1-im8130 from the ipc1-im8130.
Perform a OS Update from the copier control panel. This is
the recommended method of updating the OS software. The
controller performs a backup operation and saves the
administrator password, network settings, scan templates,
address book and other settings which are then restored
following the update.
This section provides procedures for performing each method of
Operating System update.
Update from Bootable ipc1-im8130
1 Power up the system if not already running.
2 Immediately insert the ipc1-im8130 into the drive. If the
controller was already up, reboot it. The flashing light on the
CD-ROM drive indicates the controller is trying to boot off of
the CD. If this light does not flash, leave the CD in the drive
and reboot the controller.
3 Check the LCD Touch Screen on the copier. It displays the
following message as the controller boots off of the
CD-ROM:
Starting controller. Please wait.
ipc1-im8130 Operator's Guide (Basic)