Cannot See Ipc1-Im8130 Device - imagistics ipc1-im8130 Administrator's Manual

CANNOT SEE IPC1-IM8130 DEVICE

Possible Cause
Controller is
initializing and is not
online yet
Controller is down
308
Problem Description
After installing and configuring the ipc1-im8130 controller, you
cannot see it on the network. This could be the result of controller
problems, but is more likely to be caused by network
configuration errors.
The following checklist helps you identify the source of the error
and directs to you where you can find more information about
resolving it. If the problem persists after you have followed all of
the steps, contact Imagistics' authorized dealer for further
assistance.
Troubleshooting Checklist
Cannot Find ipc1-im8130
Check
1 Did a startup page print out? If
not, wait until the controller
comes online. Examine the
protocol settings that print out
on the startup page. Are they
correct?
2 Are any error messages, such
as "Starting Controller. Please
wait." displayed on the copier's
control panel LCD?
Yes No
→
Next
Step
↓
→
Next
Step
↓
ipc1-im8130 Administrator's Guide
For
Instructions,
Go To...
Modifying
Protocol Settings
using the Control
Panel
on
page 47.
"Starting
Controller, Please
Wait" or "Shut-
down in Progress,
Please Wait"
Message Appears
on page 291.