Table of Contents
Advertisement
ipc1-im8130 Administrator's Guide
The default setting is DHCP.
Note: If DHCP is selected, the IP Address, Subnet Mask and
Gateway fields aren't displayed.
5
Enter the IP address, subnet mask and gateway address if
appropriate.
6
Enter the address of the Primary DNS Server.
7
Enter the address of a Secondary DNS Server.
8
Follow the instructions in
page 115.
Configuring SMB Settings
1
In the SMB area of the Network page, click the Protocol
drop-down list.
2
Select
to enable SMB protocol.
Enable
This is the default setting.
3
In the Device Name field, enter the controller name.
4
Enter the controller's Workgroup.
5
Enter the address of the primary WINS Server.
6
Enter a WINS Scope ID for the controller.
Note: Macintosh and Unix networks must have WINS or
NETBIOS support to access the ipc1-im8130 controller by
name instead of IP address.
7
To set the controller as a master browser, click the Master
Browser drop-down list and select
The default setting is Disable.
8
Click
.
Save
9
Follow the instructions in
Settings
on page 113.
Configuring AppleTalk Settings
1
On the Administration tab, click the
2
Click the
Network
The Network page opens.
3
In the AppleTalk area, click the Protocol drop-down list.
Configuring SMB Settings
Enable
Applying Changes to Protocol
Setup
link.
on
.
subtab.
115
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the ipc1-im8130 and is the answer not in the manual?
Questions and answers